Â鶹ԼÅÄ

Those needing more information on risk assessment can read our  (only accessible on the Â鶹ԼÅÄ network).

What is a risk assessment?

• A structured way of thinking about how an activity or situation that is going to happen at some point in the future might cause harm to people, to property or to the environment, and thereby helping you to identify measures to prevent or minimise the risk of this happening. Think of it as a safety planning tool.

Why do I need one? 

• The  requires a suitable and sufficient assessment of the risks to health and safety arising out of our work activities in order to identify the measures needed to comply with relevant safety regulations

When should I do it?

• When the activities or situations proposed present a foreseeable and significant risk of injury or ill-health
• When you don’t already have a risk assessment or safe operating procedure which adequately addresses the risks from the proposed activity; or where the review date for these has lapsed
• The earlier you do it, the easier it will be able to co-ordinate  and communicate its findings, and the more effective it is likely to be in preventing accidents or ill-health – it should not be considered a last minute task.

How should it be done?

• The basic steps are given in the HSE’s  and in our How to do risk assessment
• Make sure you have a good understanding of the proposed activity and location, so you have a good idea of what could go wrong – do your research, speak with colleagues / locals / experts
• Make sure you know about the people involved in case any have conditions or a lack of capabilities which could predispose them to risk of injury / ill-health e.g. allergies, phobias, pre-existing injuries, disabilities
• To save on repetition, you may copy previous similar assessments, but the final risk assessment must still be suitable and sufficient in describing your activities and location
• The detail in the risk assessment should be proportionate to the risks involved – simple low risk activities can be covered by simple bullet points; more complex higher risk activities will likely need greater detail
• Your evaluation of risk should describe the residual risk i.e. that which remains once all controls are in place – this should be at an ‘acceptable’ level for the activity to go ahead (see below)
• Once completed, the risk assessment should be authorised by an appropriate manager i.e. someone with sufficient competence and seniority to sanction the activities to go ahead as planned. It could be the assessor themselves, though most will prefer a second opinion. Authorisation is a check on the suitability of the planning process and the evaluation of risk – approval does not mean the transference of safety responsibilities away from those who create and manage the risks on location
• Where third parties are responsible for managing an activity for the Â鶹ԼÅÄ, they are also responsible for risk assessing it. We are then responsible for checking its suitability, co-ordinating and communicating its findings to those under our control, and using it to monitor safety performance.

Where should it be done?

• The risk assessment can either be done using the Â鶹ԼÅÄ’s  (preferred) or using the Â鶹ԼÅÄ’s  (Word). Those who complete it using the Word form should save it in the online process to help satisfy the legal requirements for record keeping and for ease of access / authorisation
• 'Last minute changes’ on location do happen. If they don’t significantly impact on the risks, you can take what additional safety measures you think necessary, if any, without recourse to your original risk assessment. However, if the changes are significant, you’ll likely need to stop what you are doing to re-visit the risk assessment process – any changes made should be proportionate to the risks involved, recorded, co-ordinated and communicated and, where necessary, authorised by an appropriate manager
• For risk assessments in News, see our Safety Short on Safety Planning of News Deployments (see Useful Documents).

Who is responsible?

• Responsibilities for risk assessment are described in Safety Responsibilities by Job Role
• Risk Assessors need to be competent â€“ for activities which are routine business, this may mean nothing more than experience in the workplace and training in the process (see Safety Training and Competence); but for other activities, it might mean needing to have relevant professional qualifications (e.g. dive qualifications for planning a dive shoot).